Return to MODULE PAGE

Installation of Parallax Software

  1. Unzip the file ParallaxSoft
  2. Run the Propeller setup up .exe file to install the Propellor software
  3. After the Propellor software is installed, import the .spin file from the downloaded zip file
  4. Connect the Parallax board to the computer via USB cable
  5. Open the Propellor software and go to the Run menu at the top taskbar
  6. Select the option "load EEPROM"
  7. While the software is loading onto the Parallax board, a blue light should be flickering on the Parallax board
  8. Once this stops, the software has been loaded